Recent content by dq72

Hello all. Been away from the small engine game for awhile. I was wondering if anyone can shed some light on the B&S "Commercial ". Is it just an Intec or whole new design or what? I'm looking @ several new mowers in the $6k range & I'm seeing these engines on some of them. TIA....

Hello, We'll as the title says-- Bush Hog ZT-180. I'm looking for anyone who owns one or is familiar with them such as a Dealer who has sold them or a mechanic who's worked on them. Thanks, David...

Hi all, I have a question for any Snapper/Ferris/Eaton experts out there. I have an Eaton 771-137 CW transaxle. Will rotating the pump plate from CW to CCW make it work in the left side of the mower. Just found out the 771-130 CCW is NLA. Any advise from you guys or perhaps a phone # or website...

Hi all, I'm lookin for an electric clutch for my mower. My mower is a Bush Hog ZT180. The clutch bearings are shot. It's a Warner CMSS-175 5218-46 and it's a dual belt clutch. Putting a used one on is out of the question. I have found a new one but it'll cost $300-$330. Not trying to sound like...

Ok, I have question for the Briggs experts out there. I've replaced some carbs on some twin Inteks latley b/c choke shafts being sloppy & sucking air. Had to replace the Carb on my own 23HP Intek last year for same the problem. Some of the carbs I pull off have what I'd call a "restrictor plate"...

:confused2:Hi, I've got a GH 727K and the engine will start but then dies when letting off of key. Any ideas??????????? Anyone??????????

Hi all, I've been working on a Yardman rider with a single B&S OHV engine. I've static timed the govenor exactly by the book. It surges when I first start it but after it warms up, it will level out and idle & rev. I kitted the carb also. I've bent the tab on throttle bracket a little bit but...

Hello, I'm in the process of rebuilding a GX 390. I'm wondering if anyone can supply me with a PDF manual on this engine. I'm mainly needing torque specs. Thank you, David.

Hi, I recently replaced the carb on my 23hp b&s intek. Had approx 260hrs on it at the time.I've also replaced the carbs on 4 other intek twins. All of them including my own had choke shafts very worn and the carb body ltself. The symptoms were increased rpm at idle and some times hard starting...

Hi all, this is my first post. I've searched on here with no luck. I've got an 18hp Honda v-twin on a Land Pride Z-Turn that has no fire. One coil has been replaced, all electrical connections cleaned, new battery. It will crank but nothing else. Any info greatly appreciated. Thanks in advance...