What guage wire is used in the GX85 wiring harness?
- Thread starter ALD2025
- Start date
-
- Tags
- wiring wiring harness
StarTech
Lawn Royalty
Actually it is mm2 [square millimeters]. About everything JD uses is metrics specs.
It is fun when it comes to tool sizes as most tool sets like to skip sizes and then you have order the sizes you need at an extra cost. Like they skip 15mm sockets in the impact sets and most of the 20mm-30 sizes. Even after years of buying tools I still run across a size I don't have. That throws a job off a week while I await the tool.
Just like this week I pulled out the deep well impact metric set to get a 15mm and was skipped. Luckily several years I needed the same socket so I dug thru the loose metric sockets and found it; although, the laser image is about gone but that is what an engraver is for.
It is fun when it comes to tool sizes as most tool sets like to skip sizes and then you have order the sizes you need at an extra cost. Like they skip 15mm sockets in the impact sets and most of the 20mm-30 sizes. Even after years of buying tools I still run across a size I don't have. That throws a job off a week while I await the tool.
Just like this week I pulled out the deep well impact metric set to get a 15mm and was skipped. Luckily several years I needed the same socket so I dug thru the loose metric sockets and found it; although, the laser image is about gone but that is what an engraver is for.
StarTech
Lawn Royalty
It is 18 Ga as I just noting that the notation was wrong as there is a between linear mm and circular mm [mm2].
I don't think an US electrical supplier would carry the wire labeled as .8 mm2. And would even probably confuse the counter person if you asked for .8 mm2 wire.
It sorta like asking for a metric adjustable wrench when it is just an adjustable wrench.