Toro Timecutter SS4235 blades won't engage

wrdabney · Jan 13, 2014

Thanks Fish, I'll do that when I get home from work today.

Carscw · Jan 13, 2014

When I had this problem it was the voltage regulator as that is what the clutch runs off of.

OUTDOOR CONCEPTS · Jan 13, 2014

Pig tail or the pto switch is a good place to start!

wrdabney · Jan 13, 2014

OUTDOOR CONCEPTS said:
Pig tail or the pto switch is a good place to start!

I've already replaced the switch. What do you mean by the pigtail?

Fish · Jan 13, 2014

Go get that model number!!!!

Carscw · Jan 13, 2014

If you could give us the model number it would make this easier for everyone

wrdabney · Jan 13, 2014

Carscw said:
If you could give us the model number it would make this easier for everyone

I will when I get off work. Are you guys referring to the mower model number?

OUTDOOR CONCEPTS · Jan 13, 2014

wrdabney said:
I've already replaced the switch. What do you mean by the pigtail?

The wire going into the clutch, maybe separated from the connector.

Carscw · Jan 13, 2014

wrdabney said:
I will when I get off work. Are you guys referring to the mower model number?

Post the mower and the engine numbers as that would make mr fish very happy.

wrdabney · Jan 13, 2014

OUTDOOR CONCEPTS said:
The wire going into the clutch, maybe separated from the connector.

I'll check that when I get home