Tecumseh Broke Rod

F

filmteknik

Forum Newbie
I think it broke initially by the crankshaft then again along its length. Punched a hole in the side of the crankcase. I can get a used rod for just $15. But I'm not sure I'm up to the level of complexity of dismantling an entire engine. I pulled the head and pushed the piston out with a tool using the new hole. What's the likelihood I can push the piston with replaced rod back in and attach it to the crankshaft using the hole which I can enlarge? I would screw some sheet metal over the hole and use red RTV.
 
Most likely not worth the effort.
I've seen quite a few Tecumseh's with broken rods, usually due to being operated with the timing too fast.
Parts and pieces from some models sell good on Flea bay.

Tecumseh's and doing repairs of this nature is in the category of dinosaur's, dinosaurs eggs and hens teeth.

AND I have few Tecumseh's and like them,

.
 
You must log in or register to reply here.
Back
Top