RZ46i zero turn ignition issue

[TrevS]

I received a barely used RZ46i zero turn made in 2013 with a smart switch keyless ignition from a family member that the switch panel doesn’t illuminate. I was hoping someone had some experience with these and could tell me a few things to check. Does this switch only need a good battery connected to illuminate or does it need some of the other safety switches in the correct state? It has a new battery but still no power at the ignition switch. Thank you for any help someone can provide.

 

[mechanic mark]

http://pdf.lowes.com/operatingguides/085388584250_oper.pdf

see if this manual helps, see page 52 & check 20 amp fuse for replacement.
Check all wiring at back of switch, tight connections everywhere. Also make sure switch is tightly mounted & ground wires are all tight by hand. Check all wire connections for rust & corrosion, wire brush will come in handy. Use silicone dielectric grease on all electrical connections after cleaning them up.

https://www.google.com/search?q=silicone+dielectric+grease&oq=silicone+dielectric+grease&aqs=chrome.0.69i59.26864j0j4&sourceid=chrome&ie=UTF-8

Detail Brush Set, 6 Piece

Amazing deals on this 6 Piece Detail Brush Set at Harbor Freight. Quality tools & low prices.

www.harborfreight.com

 

[TrevS]

http://pdf.lowes.com/operatingguides/085388584250_oper.pdf

see if this manual helps, see page 52 & check 20 amp fuse for replacement.

Thank you for the reply. Fuse checked out good, it oddly started up the next time I tried. It seems odd that it sporadically seems to have power at the ignition switch.

 

[bertsmobile1]

A wire that has broken at the crimp will do exactly what you describe