Picture of Carburetor

61solidaxle

61solidaxle

Forum Newbie
I’ve attempted to search this Forum for answer to my question/issue, but apparently I’m not tech savvy enough. So I’m posting my question hoping that someone else hasn’t already been posted it. I’m looking for a diagram or picture of the carburetor configuration for the following push mower:
- Craftsman; model: 917.388382; s/n: 062700M077713
- B&S carb: model: 12H802; type: 2675-B1; code: 0006165
The reason for the request is that I believe I’m missing a spring but am unsure because I can’t track down a good service manual or picture of my particular model.
 
Rivets said:
Look at this parts diagram, do you have the choke return spring, part number 217? https://www.partstree.com/models/12h802-2675-b1-briggs-stratton-vertical-engine
Click to expand...
Hey Rivets! Thanks for the quick response! Yes, the choke-return spring (#217) is there, but the way it’s attached, it doesn’t allow the choke to to close. In other words, with the cure two attach points, the choke is always open. That’s why I was looking for a picture of the correct configuration
 
See if this is similar enough to your mower to be correct. Different model number but could be same setup


Around the 4 minute mark shows the linkages and the spring connection locations in the video. Just pause and look and place that part of the video to see how everything is connected.
 
Yes, very close. But the linkage is slightly different. I attempted to post a picture of my carb, but the Forum sez it’s too large!?!?
 
You must log in or register to reply here.
Back
Top