How can you take off the blades on a ztr?
- Thread starter bjc
- Start date
lawn mower fanatic
Lawn Pro
I would say that's the best way.
Ric
Lawn Pro
Does anyone know how to change the blades on a Timecutter, w/o a lift, or is a lift the best way to go?
Try the MoJack Mower Lifts | Hand Trucks| Lift Accessories | Hand Truck Accessories | MoJack I use the EZ. you can buy them at TSC or Home Depot
D2hornets58
Well-Known Member
Sometimes I put loading ramps on the tailgate of a truck or on a brick wall. Then i drive up them until the mower is steep enough to get under. Then i put on the brake and put a block or something behind the back tire to stop it from rolling. As long as your careful you shouldn't have any problems.
txzrider
Well-Known Member
I used to do the ramp thing or sometimes just use my floor jack. I bought a mower so I did not have to... http://www.countryclipper.com/files/files/standup_deck.wmv
I do really like the mojack lift. The only problem I see with it... is all the times I had to check under the deck when I was away from the house.
I do really like the mojack lift. The only problem I see with it... is all the times I had to check under the deck when I was away from the house.
Ric
Lawn Pro
You better check again, it doesn't matter what size the cut, it's the distance between or of the front wheels and width of your mower is 54.6 with the Deflector Up and that will be wider than the front wheels. Your front Wheel outside span measurement should be around 42". The EZ fits my 48" cut with room to spare.
