HELP... Log Splitter Issues B&S engine

Yes, I have the same splitter.
He needs to drop the bowl nut off and clean the nut/jet first, see if that helps. Mine is very bad for getting water in the fuel/carb. He might have to remove the carb and go through it thoroughly.
 
Here is mine. I keep a plastic tote over it to keep the moisture out. Also here is the location of the model number.
 

Attachments

  • spl 001.jpg
    spl 001.jpg
    210.3 KB · Views: 5
  • spl 002.jpg
    spl 002.jpg
    194.3 KB · Views: 6
  • spl 003.jpg
    spl 003.jpg
    155.9 KB · Views: 5
  • spl 004.jpg
    spl 004.jpg
    134.3 KB · Views: 6
BINGO!!!!! Boudreaux and ILEngine were right. Cleaned out controls and cleaned nut from bottom of carb ( not very dirty but I think it had some water). put it all back together and it fired right up. THANKS guys. Now to teach my Redneck neighbor about proper maintenance.

THANKS AGAIN
 
You must log in or register to reply here.
Back
Top