21" push mower asistance

S

slomo

Lawn Pro
I have a 21RX1P Snapper push mower. It has the Kawasaki FC150V engine on her. Issue is I can't get the top engine cover off the motor. There are 4 nuts you remove to get the starter recoil assembly off. Three nuts come off easily. The last nut spins on the stud which goes down into the block, out of reach. You guys ran into this one?

slomo
 
Hello,

I looked at this engine on Partstree.com. The stud thats spinning looks like it threaded into a sleeve with a bold securing that from the bottom portion of the block. Sort of hard to explain, but I think you have a bolt spinning from the bottom section of the block (it could be obscured with oil/dirt).

Regards

Jeff
 
jp1961 said:
Hello,

I looked at this engine on Partstree.com. The stud thats spinning looks like it threaded into a sleeve with a bold securing that from the bottom portion of the block. Sort of hard to explain, but I think you have a bolt spinning from the bottom section of the block (it could be obscured with oil/dirt).

Regards

Jeff
Click to expand...

I think these four studs screw into the upper part of the block. Then a sleeve and a nut on the top side where the recoil starter is located. https://www.jackssmallengines.com/j...es26-4-stroke-engine-fc150v/cooling-equipment

I've tried gently prying up on the housing while using a corded drill on high speed. Trying to shock the nut loose with speed. No dice at all. That stud seems to just spin. Three nuts came off easy. The last one is a bear.

slomo
 
You must log in or register to reply here.
Back
Top