Search results

Results 51 to 100 of 500
  1. B

    kohler kt725-3055 wont start

    Glad you got it figured out, never seen this before though, guessing you tore it down thinking the dots were aligned if so how on earth did it run before , maybe there's other alignment marks you didn't notice , are they 180 deg apart ? Weird stuff
  2. B

    kohler kt725-3055 wont start

    Check the flywheel key and see if it's sheared
  3. B

    Fuel line placement

    You'll need to post a picture of the carb as it is now so we can see exactly what you're talking about , lots of different set ups for different carbs
  4. B

    hard start

    low Voltage can Cause this also
  5. B

    10795 Lawnboy, Honda Engine, Can't start-- appears no spark

    Remove the kill wire off the coil and check for spark , if it gives you spark the problem is with the wire if not, it's the coil assembly.
  6. B

    FX730V Bogs under load

    I'd pull and clean the carb and make sure the filter is not dirty, I tried E85 fuel one time and had to keep it choked partially to keep my mower running , also the governor linkage may be sticking and not able to respond when you get into thick grass
  7. B

    445 rancher fuel leak

    There are 2 grommets where the fuel line goes into the tank that need changing as well, if it leaks when you prime it , look at the primer bulb lines to the carb and return back to tank
  8. B

    FX730V Bogs under load

    Check your fuel lines for good flow , when did this start ? all of a sudden or has it been acting up over time ? New components don't mean they're good , I've put new carbs on thinking that eliminated the carb from the issue and was still the carb, same with fuel pumps etc. It does not sound...
  9. B

    Carburetor smoking?

    I've never seen a carburator smoke , I think you're seeing exhaust , nothing comes out of the carb , only air / fuel intake at that point , if it backfires you may see something there but would not be running good if so , this smoke is coming from somewhere else
  10. B

    Hi everyone!

    Just don't scalp your lawn , it will get thick and healthy as long as you don't cut it too short. I'm in South Louisiana but doubt it's any different up there
  11. B

    Looking for bolt size

    Look it up on Amazon , for replacement parts for that machine,
  12. B

    Bad Boy MZ Magnum zero turn won't start

    There are small terminals on your solenoid , one is ground the other comes from your key switch, and should have 12 volts when you turn the key , if it sees 12 volts and does not engage the solenoid and turn the engine over , it's your solenoid . you can jump 12 volts straight to that terminal...
  13. B

    Starter not fully engaging flywheel

    You going to need another flywheel no matter what , how did this happen ? did the starter get changed at some point and begin chewing up the flywheel , it would have made a sound like grinding or something , I've never run across this in the past
  14. B

    Replacement Throttle Cable is Too Long?

    If it's a metal sheath , I've cut the outer sheath before and then cut the inner cable to length , you'll need to re bend the end to fit the carb linkage and that's a little tricky ,
  15. B

    Mower drive belt problems

    make sure your routing is correct , the old belt was surely stretched a bit , it's easy to route the belt wrong
  16. B

    Starting Trouble Honda GX-340

    If it wont fire with ignition fluid , you have an ignition problem , clean up the coil and flywheel area with some emery paper , pull the plug and ground to watch for a spark , should be good healthy spark not weak, if you don't see anything, -- I hold the coil wire and pull the starting rope...
  17. B

    7000 seeies 26 hp won't start

    Sounds like a bad connection somewhere, when you push the mower , the piston is not moving so that's not the issue
  18. B

    Z5424 Mower deck wont engage.

    You should have 12 volts coming into the clutch engagement switch , if not work backwards to find out where the voltage drop is .
  19. B

    How will the new 15% ethanol gasoline affect our Craftsman mowers and lawn tractors?

    I tried some E85 fuel on mine and had to use the choke to keep it running , not sure about the 15% ethanol stuff..
  20. B

    Simplicity Broadmoor PTO Bolt

    Make sure it's not left hand thread , if you snap off the head , you'll be drilling out the broken bolt and that's no picnic , I have not seen a left hand thread on the clutch drive but you never know
  21. B

    Spartan zero turn ignition key pad

    This was a problem for Spartan machines , they actually sell a kit to bypass / work around this key pad Screwup I chose not to buy one for this reason , not sure where to get the kit but sure someone on the tube will address it
  22. B

    Repeat Carburetor Problems

    I just turn it upside down and try to blow through the fuel inlet , you should not be able to push air through it , then turn it right side up and do the same thing , air should flow easily, if pass all test , take apart and look at the jet , pull and clean , you should be able to see the hole...
  23. B

    electric clutch

    Test your Clutch engagement Switch , with the key on and switch engaged you should see 12 volts at the switch , if you do , then chase the wires to where they go to the clutch itself and see where the power drops off . may just be the switch , some have extra terminals and you can just move...
  24. B

    Won't restart after safety shutdown

    Fuel solenoid only shuts off fuel supply , if it's a safety switch it will not allow the starter to engage
  25. B

    Craftsman T260 Melted Wiring

    Not sure of your skill level but When I run across wiring issues , I start from scratch with new wires to simplify everything You need 12 vts to the ignition key switch , from the On position voltage should go to the clutch engagement switch then to the clutch, also power from the same...
  26. B

    Won't restart after safety shutdown

    So if I understand you right, it spins over after it stops but will not fire, after 30 min or so it cranks off with no problems , If it was a safety switch it wouldn't spin at all , It however could be a low oil level safety which will not let it start, after sitting for a time , the oil...
  27. B

    Engine will not start (6hp model 122H02-0220-B1)

    Verify it's getting fuel , it must have a spark if it ran for a few minutes, fuel lines tend to collapse and or dry rot if it's sat around for a few years
  28. B

    Kohler Courage 23 Carburetor

    I've mostly gotten good carbs off Amazon , once in a while you get a bad one but most times they'll take it back , try them again
  29. B

    Suspect carb problems

    If there's no click with the key " on " check for power at the terminal on it, use a test light- no light , work back towards the key switch - it will not run unless it opens to allow fuel flow
  30. B

    D140 carb replace, choke not working

    If it has a choke you can see it close / open when you activate the lever. Compare it to the action on your original carb, Lots of carbs now days only have a primer bulb
  31. B

    John Deere LX188 No crank

    Check battery voltage and starter connections first , the click you hear is probably the solenoid
  32. B

    koher ch25 motor runs very rough

    Does it smoke when running ? Does it idle rough or run rough at all speeds ? Has anything been done to the machine prior to this ?
  33. B

    X530 click no turnover

    If it's a safety switch you wouldn't even get a click. it sounds like a bad ground connection or battery connection . Clean everything and try again.
  34. B

    Kubota gearbox

    Here is the parts diagram for the one I worked on , maybe it will shed some light, I also have the parts list for it if you need
  35. B

    Kubota gearbox

    Pull it off the machine , bring it to any Kubota dealer and they can show you a breakdown of all the internals and price replacement parts, you may find something on ebay as to a used gearbox - I'll be willing to bet a new replacement box would be costly .
  36. B

    Convert GAS Briggs V-Twin to DIESEL?

    No way is this a good Idea.
  37. B

    Kubota gearbox

    Going to need more information like model , year etc. If it's the one I'm thinking about , it can be rebuilt - I've done a couple of them - Parts have to come from Kubota - gears, bearings, seals a shaft if necessary. post a few pics as well .
  38. B

    Broken Con Rod 44N677

    Fixing it is doable but finding out why is more important ,this is a major failure that rarely happens
  39. B

    husqvarna yth1542xp Won't move forward or reverse

    Jack it up and try the shifter and watch the drive belt / pullys to figure out where the problem is ,
  40. B

    950M Zero Turn

    All types of oil have a spec sheet , your owners manual will specify what your machine requires, There will be something compatible
  41. B

    Kohler Courage 20---what beside main crank seal will quickly dump all oil from under engine?

    I ran into this with the same engine, I think there is a design flaw on this model , mine threw the rod and busted the crankcase.
  42. B

    Safety switch problem on Husqvarna Z248F zero-turn mower

    There are safety switches on each of the leavers you mentioned
  43. B

    Cub Cadet RTZ50 Stumbling Under Load

    Clean the carb
  44. B

    Gator won’t start.

    Better look at the fuel supply side , hoes etc. drop fuel supply into a fresh container of fuel and see what happens
  45. B

    PTO clutch vibration

    check your belt
  46. B

    Honda engine replace/rebuild

    Look at the spec sheet on both, mainly the footprint / mounting bolts , shaft size etc.
  47. B

    Ferris 3100Z leaking

    what size is the largest one ? If it's under 2 inches in diameter , the O ring kit will probably have it
  48. B

    Ferris 3100Z leaking

    Not sure what size the o rings are but an O ring kit may have one you can replace it with , I've had to build o rings in the past with o ring stock and superglue when push comes to shove
  49. B

    Ferris 3100Z leaking

    Pull the motor and remove the seal, there should be a number on it for replacement , I'd get 2 so you'll have a spare
Back
Top