Search results

Results 1 to 50 of 500
  1. H

    PTO clutch replacement

    I have a set of torques sticks I use but set did not include the 55 ft lbs. some clutches recommend had to buy it separate
  2. H

    Mulching blades JD s240

    Probably not Best bet would be Gator blades work well on leaves.
  3. H

    Parts source requested

    Briggs does not list those engines anymore. parts tree does and superseded part numbers. parts are listed on E-Bay
  4. H

    Hi everyone!

    Welcome aboard glad to have you.
  5. H

    Chain saw advise

    I have a TBC340 Tanaka trimmer never had a carb issue still going strong. I always run non ethanol. Bought it new in 2004.
  6. H

    2011 JD Z425--54-inch Zero turn. sale it or part it out?

    Go to You tube look up Taryl fixes all on how to fix the valve guides that have moved in the head. Have a friend who says he never gets the push rod out of the engine. Says he has one with three in the pan now and they never have caused an issue. I had one that lost the push rods and pulled the...
  7. H

    Briggs and Stratton Model 44N877 Type 0003G1

    Needle should have a rubber tip
  8. H

    What has happened to my Kohler ?

    I always check my oil before starting to mow. I see way too many come in with low oil and loose filters as well not to. l
  9. H

    New Member

    Welcome aboard
  10. H

    Chain saw advise

    The common demonator is if you don't start it right. I have seen a lot of older gentlemen come in and say I can't start my saw. They are not as young and strong as they use to be and have a hard time pulling it over to start. That is the reason I would recommend the easy start.
  11. H

    Plastic Trans

    I have a Husqvarna that has a bad engine but I live in north middle Tn. Mine has a SV600 series Kohler single cylinder Engine on it.
  12. H

    NIKKI CARBURETOR HELP

    I have bought several of the aftermarket Carbs with the accelerator pump have not had an issue with one yet.
  13. H

    Hello from central Ohio

    Welcome from North middle Tn.
  14. H

    Plastic Trans

    You might look for a similar mower with a bad engine with the hydro drive and switch engines.
  15. H

    Chain saw advise

    Stihl and depending on your age if elder get the series with the easy start. get them to show you how to start it.
  16. H

    Howdy

    You mean posting I have a red mower with black wheels don't get it.
  17. H

    Ever hear of using hot to decarbon a running engine?

    My brother says he has ran hot water thru the engine while running to remove the carbon from an engine while running. Ever hear of it?
  18. H

    Kohler SV-600 Air Gap

    First thing that needs to be done is adjust the valves
  19. H

    Kohler SV-600 Air Gap

    Don't know why anyone would tell you to hold the ignition key to start position and hold it there until the starter turned the engine past the compression stop position. That could burn the starter up. turn the engine backward until it comes to the compression stop position. Then turn it...
  20. H

    Hello

    Welcome aboard old or new stuff?
  21. H

    Lift cam

    You mean it is a red mower with black wheels is not what you need. LOL
  22. H

    2004 727k2 won't charge battery

    [URL Check this out unfurl="true"]https://partnersportal.kohlerpower.it/customer/downloadareagas/api/v1/filemanager/download?file=Service%20Manuals%2F24_690_07_EN.pdf[/URL]
  23. H

    No start zero turn Kohler 7000

    Check the PTO fuse and all the fuses. Could be the PTO switch as the start circuit goes through the PTO switch. The faint click you are earing is probably the fuel solenoid in the carburetor.
  24. H

    Since Dixie Choppers are no more is there any parts we should be buying up / hoarding

    We never bought the original clutches from DC bought the Xtreme Clutches never had to replace one of them yet been using them for years. Much cheaper than the original. https://xtremeope.com/p/xtreme
  25. H

    Does anyone have a current repair manual link for the KT735 series engines?

    Ok Don't blame you for that.
  26. H

    Since Dixie Choppers are no more is there any parts we should be buying up / hoarding

    Hate to see them go I own 3 Running 2 not running and two junkers. 3 of the running ones are 1997 1999 and 2000. Year models they just don't die. The other two fixer uppers are 2010- and 1999-year models.
  27. H

    Kohler SV-600 Air Gap

    We all have days like that no problem
  28. H

    JD 757 only runs and moves when the PTO blades are engaged.

    Good to know thanks
  29. H

    Does anyone have a current repair manual link for the KT735 series engines?

    Why are you replacing the heads?
  30. H

    BadBoy Maverick HD Starts and Runs Fine Then Engine Surges

    Post model and spec no of the engine.
  31. H

    Hydraulic System

    Have to put the mower on jack stands and release the hydros. To release the hydros, find the 5/8 headed bolt heads with holes through them and open about two or so turns. Start the engine Move the controls back and forth 8 to 10 times. Close the release valves lower the mower to the ground and...
  32. H

    "Backyarders" and where to buy used equipment

    At an auction you are buying a pig in a poke.
  33. H

    Since Dixie Choppers are no more is there any parts we should be buying up / hoarding

    Was at where I use to work and they are telling me the parts will still be available through Rino Ag. a Division of Alamo Group, Was told you can potentially buy a new mower for 50% off.
  34. H

    8Ten mower deck spindles

    The new style ones are not rebuildable or greaseable. I usually replace the bearings in the old-style spindles. Looks like some of the ones listed are rebuildable and greaseable. Be sure and get the long shaft one for the center spindle.
  35. H

    "Backyarders" and where to buy used equipment

    Let's see a new mower 19 20 HP 42 inch deck gear drive retails for $2200. How long will it last. 10 years? $2200 divided By10 = $220 depreciation per year. So, if you get it when it is 5 years old is it worth $1100 resale value?
  36. H

    "Backyarders" and where to buy used equipment

    That is where you have show them what you have done to it to show it is worth the $600 plus the $150 you paid for it. I would not put that much money in a low end MTD CC Husqvarna or Craftsman mower.
  37. H

    "Backyarders" and where to buy used equipment

    What I have started doing. I make a work order showing what I have done to it and what it would cost to fix it. Let them see what it would cost to fix it as compared to one they would buy that needed that work done to it.
  38. H

    "Backyarders" and where to buy used equipment

    I buy trade and sell mowers. I fix everything that needs fixing. I take the price I gave for the mower the price it took to repair it and add a little more to it and sell them for that price. This year has been a rough year to sell anything but zero turns. Had a Craftsman 26HP 54 inch deck was...
  39. H

    Kawasaki FD440V steel camshaft

    https://www.amazon.com/Caltric-Compatible-Camshaft-Kawasaki-4-Stroke/dp/B0B9NRFS4D/ref=pd_lpo_d_sccl_2/134-1376377-8603751?pd_rd_w=hS8zR&content-id=amzn1.sym.4c8c52db-06f8-4e42-8e56-912796f2ea6c&pf_rd_p=4c8c52db-06f8-4e42-8e56-912796f2ea6c&pf_rd_r=M9ZK952JSA79274B6AMC&pd_rd_wg=I3dAb&pd_rd_r=5a2d7...
  40. H

    Blades Disengaging

    RMC ignition switch or switches on the lap bars.
  41. H

    JD LA120 deck vibration

    Check and see if anything is wedge in the pulleys or a bent pulley
  42. H

    Wide mower with multiple blades not cutting properly

    Take the other 6 blades off and see how that works out.
  43. H

    8Ten mower deck spindles

    Have used them a lot never had a problem with them.
  44. H

    Tecumseh Broke Rod

    The crank journal is most likely galded and will needed to be cleaned up
  45. H

    How to Tell when Deck Spindle is Going Bad?

    Sounds like it.
  46. H

    Uneven Grass Height with JD srx75

    Sounds like The blade tip is set higher in front than rear
  47. H

    Kohler SV-600 Air Gap

    If the coil is hitting the magnet on the FW there should be scuff marks on the magnet, if there are no scuff marks on the magnet. It could it be loose magnets under the fly wheel scrubbing against the against the stator.
  48. H

    Kohler SV-600 Air Gap

    .008 to .010 I set it to .010
  49. H

    Funny Dealer

    Dixie Chopper through the years. https://www.dixiechopper.com/our-legacy/ Still going strong in some areas. I own five three running and two fixer uppers. The fixer uppers will be sold which I have one almost ready to go. They sell good in my area.
  50. H

    Raptor SD mower deck belt

    If the belt is crossed the blades will be running backwards
Back
Top