New profile posts

Results 171 to 180 of 490
M
S
SamD
Thanks Mark! I've seen those - pretty pricey for the one little part I need. What do you think my chances are of being able to successfully MIG weld the one of mine that snapped in half? S
D
I don't want to comment further on the thread about ZTRs and towing, especially since the OP has said he won't be towing. I've seen all sorts of recommendations for towing from none for small machines with light-duty transmissions all the way up to 2,000 pounds. I agree that you need to follow the MFG recommendations. My point is that towing with a Z often is appropriate and within the MFG recommendations.
D
BIG DOG ALPHA 54 ZERO TURN BELT DRIVE PROBLEMS .....I ONLY HAVE 49 HOURS. it's my 2nd year....I've torn, broke , sheared pins ...every week but one . I'm taking it to the shop 1 a week. HELP....ANYONE ELSE HAD THIS PROBLEM?????

...
cpurvis
cpurvis
If you move or re-post this in the Big Dog forum, a lot more people will see it.
R
hey ya'll New to this forum and forums in general. I've had a42" Raptor for 3 or 4 years with very few problems. My wife loves riding it. But yesterday it suddenly began going in a circle. All the linkages and rods for the steering appear to be fine. Any suggestions where to look next. Thanks
cpurvis
cpurvis
You might want to repost this in the Huster forum where more people will see it.
H
Hi Mark,

I tried attaching the service info for your mower, but even when I tried attaching half of the file, it says it to big to attach. If you want to share with me your email address, I could send it to you. FYI - I'm the Honda service manager for 6 NW states.

Best regards,

Jim L. (HondaTech)
C
Have clipper elite 6020, 1998,
it's a tank, want to keep the old girl runnning.
and looking for info on drives. K
Kohler command has oil leak on valve cover, going to try a new one, looks like it was distorted from over tightening. instead it probably only needed a new o ring.
I have the manual and the parts book. they are good for several models.
I think Oregon can supply the blades, still checking out.
  • Like
Reactions: poppop ron
cpurvis
cpurvis
You posted this on your profile. More people will see it if you post it under the manufacturer's (clipper elite? or Kohler) forum.
poppop ron
poppop ron
All you need to do is remove valve cover clean it real good and get some good gasket sealant like Peratex, Tighten all 4 bolts equally to avoid warping
cpurvis
This problem has been discussed at length in either the Grasshopper forum or Kubota forum. It's a fuel starvation problem. Go over there and read about it or re-post your problem there.
If you had a fuel pressure gauge, it would NOT look good.
  • Like
Reactions: Jsalanoa
Jsalanoa
Jsalanoa
Just registered on here once I got the problem. Thank you
Jsalanoa
I have a 721D Grasshopper mower that is having issues. After it is running for awhile the mower will quickly lose power and rev back up to full power. Sometimes it lose power all the way down until it shuts off. Does anyone have any ideas of what it could be? Guages all look good when it quits on me.

Footer Links 1

Top