Latest activity
-
Its Me replied to the thread 8 inch stripe longer grass being left?.whynot, could you post a photo of the mower, even one maybe to routing of the deck belt on the mower, gosh there is enough of us skilled... -
JJoeKarpowski replied to the thread 8 inch stripe longer grass being left?.Check the spindle to the blade that's not cutting correctly. Over the years, I've had several that wouldn't spin full speed just before...
-
PPorthos replied to the thread ZTX4 spindle disassembly.✅ Thanks. I'll get it disassembled then go from there.
-
PGotcha. I think I had one like that on a LT1045??? I never did figure out how to remove the bearings. Good luck!
-
PYou cannot remove the bearings without damaging them. Only possible way would be to put the spindle in a press and then may sideload...
-
PIt appears that you need remove the spacers on each end. Then press out #10 spacer using a driver that slightly under under 30mm OD in...
-
PCub Cadet Website using model ZTX4-60 KH FAB (47ASAAA8010) (2021) (ULTIMA ZTX4). Then look spindle assy diagram. The bearings are...
-
ILENGINE reacted to Auto Doc's's post in the thread Customer states, hit a stump and now deck is making terrible noises with
Like.
If you really want to get a puzzled look on their face, ask them to bring in the missing parts so you can weld each of them back... -
JJP98 replied to the thread Ariens Zero Turn Ikon XD 52 - dead!.Well, it turned out to be the damn battery. I charged it all day and it started. I was able to cut the grass but when I shut it down and...
-
JCheck the wiring diagrams. You will need the model number and serial number to find them.
-
MMParr reacted to Scrubcadet10's post in the thread Customer states, hit a stump and now deck is making terrible noises with Like.
"I just need this sharpened"
-
MMParr reacted to Auto Doc's's post in the thread Customer states, hit a stump and now deck is making terrible noises with Like.
I have a bad scar in my shin caused by a push mower blade fragmenting like one of these shown. People don't realize that checking and...
-
AAuto Doc's replied to the thread Customer states, hit a stump and now deck is making terrible noises.If you really want to get a puzzled look on their face, ask them to bring in the missing parts so you can weld each of them back...
-
MMr G replied to the thread Badboy ZT Elite FR730v clutch bolt.All, this is a delayed update. To last years issue but had to make sure the fix lasted. So, I took the advise to replace the bolt and...
-
Update: Here are the plugs after 4 hours on a new carb and two new ignition coils. Plugs in same position as before.