Latest activity
-
Ssteves snapper replied to the thread intek 12.5 hp engine cylinder head gasket need to confirm part #.hlw49 I'm done w/ TDC wasted about 4 hours. I managed to adjust the valves lower valve set to .004 top valve .006 she did crank up. I...
-
ILENGINE replied to the thread Kawasaki FD750D-AS04 running poorly.This thing has already been through the 2.3 gallon 6 transducer ultrasonic cleaner for 2 30 minute cycles, plus had all the passages ran... -
PPorthos replied to the thread ZTX4 spindle disassembly.Thanks for that good info ! Where does that diagram come from ? "... the spacers on each end" ; would that be #8 on top and #11 on...
-
ILENGINE replied to the thread Kawasaki FD750D-AS04 running poorly.Spraying around intake manifold gaskets does nothing. Spraying into the carb causing a rich run. I have since discovered posting...
-
Hhlw49 replied to the thread intek 12.5 hp engine cylinder head gasket need to confirm part #.Watch the video. Engine has to be on top dead center on the compression stroke to adjust the valves.
-
ILENGINE reacted to Auto Doc's's post in the thread Customer states, hit a stump and now deck is making terrible noises with
Like.
I have a bad scar in my shin caused by a push mower blade fragmenting like one of these shown. People don't realize that checking and... -
ILENGINE reacted to Scrubcadet10's post in the thread Customer states, hit a stump and now deck is making terrible noises with Like.
"I just need this sharpened"
-
Ooutdoorpowermike replied to the thread Kohler Command V-twin. Cranks but no-start..Put vac gauge on suck port, should have -1.5 reading red side, put gauge on push port going to carb should have +1.5 reading green side...
-
Ooutdoorpowermike replied to the thread Kohler Command V-twin. Cranks but no-start..Put vac gauge on suck port, should have -1.5 reading red side, put gauge on push port going to carb should have +1.5 reading green side...
-
AAuto Doc's replied to the thread 28607 possible ignition issue - not really sure..Some starters have metal pinion gear option, but it has to have the correct tooth count. The other suggestion is to replace the entire...
-
Ooutdoorpowermike replied to the thread Kawasaki FD750D-AS04 running poorly.Ok, from what you say the carb needs to removed and cleaned the correct way, with a ultrasonic cleaner, I use it every time with lean...
-
Ooutdoorpowermike replied to the thread Kohler Command V-twin. Cranks but no-start..If these test show positive you have a defective fuel solenoid or fuel clog from fuel supply ( the fuel tank) to the fuel pump.
-
Ooutdoorpowermike replied to the thread Kohler Command V-twin. Cranks but no-start..You can test the fuel pump. The suck side should have 1- 1/2 neg vacuum. Out side to carb should have 1-1/2 psi. You can check these...
-
AAuto Doc's replied to the thread Customer states, hit a stump and now deck is making terrible noises.I have a bad scar in my shin caused by a push mower blade fragmenting like one of these shown. People don't realize that checking and...
-
Yyinmeout replied to the thread 28607 possible ignition issue - not really sure..Yeah I have yet to see anything as reliable or with the kind of lifespan of a snapper on the market today. After the oil pan filled...