Latest activity

Unless you're going tto trash that motor, find out why the rods bent. Examine the valves and rockers. Are they way out of adjustment...

I have a Toro I think it’s a recycler model , number 20381. I have a bad transmission on this lawnmower and I can’t seem to find a...

I would rather replace the belt on the 445 deck than replace the belt on the JD freedom deck.

The make and model or the manufacturer label information is needed from you. We are basically guessing at this point. Help us help you...

I have a 445. I will never take the deck off that thing again!

I agree there. I do have over $100,000 in inventory and most of it seldom moves. Still having to buy a lot of parts from the...

Are the blades all installed the same, or is one upside down? I've seen it happen before. Also, all of the blades should be identical...

Engage the Parking Brake and flip seat back. + to +. Do NOT jump with a vehicle with the vehicles engine Running. Catastrophic...

And if an independent shop can look at it, the time frame for completion depends on if they have all the parts in stock. If not that...

Disconnect the coil kill wire on each coil and see if the engine now runs on both cylinders. The engine can be shut down by the...

Thanks! All set! That was it!

It runs smooth when not moving or cutting anything. However, if it bogs even a little on heavier grass, it starts to surge and won't...

I have an ex mark E series with a FS 600v the engine has 1200 hours. The engine bogs down when i engage the blades, it takes about 5...

As long as you learn from your mistakes you will become a better tech. It is when you don't learn and keep making the same mistake over...