I have a Husqvarna i Z 4817. The battery is new and checks at 12.54 amps. Everything is in the normal starting position however all that happens is the Starting solenoid will click. It also checks at 12.54 amps. Any ideas on where to check next?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Will not start
- Thread starter CCT1114
- Start date
More options
Export threadbertsmobile1
Lawn Royalty
- Joined
- Nov 29, 2014
- Threads
- 64
- Messages
- 24,702
Different way of doing the same checks as Rivets is doing
1) remove the spark plugs & try again
2) run a jumper from battery - to a good ground near the starter & try again
3) with the above jumper still there run another from the starter motor to the battery + Best done that way because you get a big spark .
Post your results
1) remove the spark plugs & try again
2) run a jumper from battery - to a good ground near the starter & try again
3) with the above jumper still there run another from the starter motor to the battery + Best done that way because you get a big spark .
Post your results