tecumseh 10hp Sears LT 10 carb. and linkage

silver1

silver1

Well-Known Member
I would like to have a picture/drawing of the throttle linkage assy. to this carb.

I may want to purchase a new /rebuilt carb.

Any help would be great. I have owned it for 2weeks now!
 
If you haven't taken it off yet, take a photo.. or draw it down on paper.
 

Attachments

  • Screenshot_1.png
    Screenshot_1.png
    72.3 KB · Views: 56
Your photo is showing the throttle/governor link and you should have a spring for it to, has your engine got a air vane governor because you say that the photo that posted up is not like yours so therefore its not mechanical.
You should be able to work it out now by the pic that I have posted.
If you need more info then this, then we need more info from you, like engine/type numbers.
 

Attachments

  • Screenshot_3.png
    Screenshot_3.png
    133.2 KB · Views: 47
Your # 30 looks similar. I took some more pic. The one shows what I think is the correct setup using a paperclip for reference.

I need help with the serial/type motor plate location. Is it by the spark plug?
Thank you so much for your time.

It looks like I will be parting out my YTV/16 as the motor is broken! The 656cc twin 16hp
has a broken rod

LB
 
The loop end (pig tail) is where the spring go's on to, if you look at your No 1 photo you will the spring on it.
other link go's between (A) and (B)
 

Attachments

  • Screenshot_4.png
    Screenshot_4.png
    29 KB · Views: 25
  • carbb&s.jpg
    carbb&s.jpg
    81.4 KB · Views: 33
  • Screenshot_1.png
    Screenshot_1.png
    33.2 KB · Views: 27
  • 1-IMGP0005.JPG
    1-IMGP0005.JPG
    180.4 KB · Views: 29
Last edited:
EngineMan said:
The loop end of the link go's on (B Governor arm) and the spring also go's into (onto) the loop.
Click to expand...

I'll move them over to the throttle. Is there a part that would go were the spring was mounted now?
Do I only need the wire (see pic) and spring?
 
You must log in or register to reply here.
Back
Top