Can anyone out there confirm what hole on the steering bracket the power steering cylinder should be mounted to? I bought a used 2010 Simlicity Prestige 4 wheel drive last year. This year the steering bolt on the bracket broke off. I replaced it and it swiftly broke again. After further inspection I noticed the boll joint was bent and wore badly. One thing I noticed on all of this when ordering new parts the parts diagram shows the bolt going through the front hole not the center hole I found mine mounted in. So I talked with my dealer about this and they are less than knowledgeable, but they told me the diagram is just a general representation and could go in either hole depending on how its set up. Anyway I tried it in the front hole but it defiantly limits the amount it can steer now. Is there anyone out there with one of these that can tell me which hole this should be mounted in? Thanks!