Hi Friends, I have a 1998 Toro Z-Master 62'' cut with a 25hp Kohler engine. I bought this with a blown head gasket and quite a few other problems, it has had a rough life, it had been neglected and everyone and their brother must have worked on it and none of them knew what they were doing. Long story short...I have repaired most every issue with it:thumbsup: but the governor is not working.:frown: I can move the governor linkage with my finger and it speeds up or slows down fine, I doubt the linkage is hooked correctly but I don't know that for sure. How can I know if it is a linkage problem or something serious like a cam gear or something?:mur:
All help is appreciated!:anyone: Thanks Cregg
All help is appreciated!:anyone: Thanks Cregg