i inch to 1 1/8 inch motor swap.

[now151]

i want to swap a toro 1inch shaft 708cc engine for a Kawasaki fx 730 if possible. will i have any trouble getting a 1 1/8 inch clutch to replace the 1 inch clutch. is there any other problems that might show up. the mower is a toro 74490 zero turn z master 2000 48 inch cut.

 

[Auto Doc's]

You can get a clutch, but you will need a wiring diagram to connect everything electrical in most cases like this. You may also need a drive pulley with the correct spacer.

 

[now151]

You can get a clutch, but you will need a wiring diagram to connect everything electrical in most cases like this. You may also need a drive pulley with the correct spacer.

some toros come with kawasakis already so im assuming there is a clutch that will have the 1 1/8 bore to fit my application. ill have to look around to see if i can find some type of electrical diagram to cross reference the wires.thanks for the reply.

 

[hlw49]

I assume you already have the engine or are you going to have to buy it. They make an FX730 engine with a one inch shaft. The shaft has to be the right length as well.