Shamrocklex
Forum Newbie
- Joined
- May 26, 2019
- Threads
- 1
- Messages
- 2
I have a Husqvarna YTH24v48 4 yrs old.
Has been operating fine since new.
I was cutting the first time this year and the mower deck belt came off. With it still running I drove it back to the garage and shut it down. Saw that the belt was off. I went to start it back up to drive it in the garage and it just clicks will not turn over.
I removed the deck, rerouted the belt and put the deck back on. Still just clicks.
I have jumped it with my truck, replaced the battery anyway as it was getting weak.
Replaced the solenoid with a new unit, still clicks.
If I jump across the solenoid terminals it turns over but doesn't start.
Any help would be appreciated. Thx!
I don't seem to be getting power at the key wire on the solenoid when the key is in the on position.
Is there a sensor for turning the blades on preventing the power to the solenoid?
Has been operating fine since new.
I was cutting the first time this year and the mower deck belt came off. With it still running I drove it back to the garage and shut it down. Saw that the belt was off. I went to start it back up to drive it in the garage and it just clicks will not turn over.
I removed the deck, rerouted the belt and put the deck back on. Still just clicks.
I have jumped it with my truck, replaced the battery anyway as it was getting weak.
Replaced the solenoid with a new unit, still clicks.
If I jump across the solenoid terminals it turns over but doesn't start.
Any help would be appreciated. Thx!
I don't seem to be getting power at the key wire on the solenoid when the key is in the on position.
Is there a sensor for turning the blades on preventing the power to the solenoid?