Governor Springs Assembly on a 3.75 Briggs and stratton

[CJMO1234]

Hi, I recently purchased a 20" Murray push Mower equipped with a 3.75 Briggs and Stratton Model 9L902-0213-E1. Unfortunately the air link vein and the governor springs were not attached and i can't for the life of me figure out how to get it back together, I was wondering if anyone can post a diagram or help me out with it.

 

[vogtrj]

If you haven't seen this, it may help: http://bsintek.basco.com/BriggsDocumentDisplay/18mrAHX-nfBhU7y.pdf - Page 13

I hope it does.

 

[AnthemBassMan]

-Not sure if you've fixed it yet, but here's a pic of the carb.

L8R,
Matt

 

[CJMO1234]

Thats it exactly but i do not have the plastic piece that the govenor idol sits on. What is that part called?

 

[CJMO1234]

this is what i am looking at, Thanks

 

[AnthemBassMan]

Ah, I see yours is broken off. That part is called the air vane governor, or something similar. I found one on eBay from a Briggs 3.5hp engine that should fit yours. But you should get the engine # from the shroud on yours to make sure. Here's a link to it.

Http://m.ebay.com/itm/360930900597?nav=SEARCH.

L8R,
Matt

 

[EngineMan]

If I have your engine number right the parts are.....

691912 Blade-Governor
and if you need the other parts which are....
690347 Link-Air vane
691297 Spring-Governor
691859 Spring-Governor Idle

But please check before you order.

 

[CJMO1234]

Thanks a bunch! ordered the part, should be up and running properly in a few days

 

[AnthemBassMan]

No problem. Do you have the linkage and springs too? If you do have the springs, make sure that they aren't stretched out. The governor works as a fine balancing act. One weak part throws the whole thing off.

L8R,
Matt