I have a Toro 20333 mower with a B&S engine. I tried to remove the plastic clutch cover to clean behind it but couldn't figure out how to get it off. Since then, the mower vibrates when the blade is NOT engaged, but runs smoothly when the blade is engaged. I'm not sure that this was the cause though.
Someone suggested a bent crank or drive shaft but I would think that would cause vibration all the time, not just when the clutch is disengaged.
Any ideas?
Someone suggested a bent crank or drive shaft but I would think that would cause vibration all the time, not just when the clutch is disengaged.
Any ideas?