For the life of me I can't figure out how to replace the deck belt. The drive belt pulley is over the deck belt pulley on the spindle and it's a bigger pulley that's tight up against the deck. Was wondering if their is a best way to replace. Right now I'm looking at either pulling the pulley or the spindle.
Everride warrior 60 zkw2560 deck belt
- Thread starter Joshoooah
- Start date
bertsmobile1
Lawn Royalty
That would be the only mower that has this set up
Every other mower I have worked on, around 5000 or so, the smaller pulley is the transmission & the pulley stack has it on top .
Was this mower bought new or used ?
I can not find a parts breakdown for a zkw2560 , the closest I can find is a ezkw2352
Now the exploded parts diagram is printed upside down , and it shows the drive pulley above the clutch pulley remembering that the top of the image is the bottom of the mower ( note the position of the lap bars )
Every other mower I have worked on, around 5000 or so, the smaller pulley is the transmission & the pulley stack has it on top .
Was this mower bought new or used ?
I can not find a parts breakdown for a zkw2560 , the closest I can find is a ezkw2352
Now the exploded parts diagram is printed upside down , and it shows the drive pulley above the clutch pulley remembering that the top of the image is the bottom of the mower ( note the position of the lap bars )
EverRide 992407 - EverRide Warrior 60" ZT Zero-Turn Mower (SN: 000101 & Above) Belts, Idlers, and Blades Parts Lookup and Diagrams | PartsTree
Find genuine OEM replacement parts and diagrams for the Belts, Idlers, and Blades for the EverRide 992407 - EverRide Warrior 60" ZT Zero-Turn Mower (SN: 000101 & Above)
www.partstree.com
bertsmobile1
Lawn Royalty
Nothing to reference that parts break down against
When you get under the mower and look up do you see the drive belt ?
If so then some brain dead moron has the diagram upside down and some equally brain dead mechanic has installed the clutch & drive pulleys the wrong way round on the PTO shaft.
That is what happens when daddy gives his 5th generation inbreed son a job in the factory because you can draw all of the bits on a computer
For the set up to work as depicted then there would need to be another flat plat e above the belt for the engine to bolt onto and unless the engine is running backwards the tension pulley is on the wrong belt run.
When you get under the mower and look up do you see the drive belt ?
If so then some brain dead moron has the diagram upside down and some equally brain dead mechanic has installed the clutch & drive pulleys the wrong way round on the PTO shaft.
That is what happens when daddy gives his 5th generation inbreed son a job in the factory because you can draw all of the bits on a computer
For the set up to work as depicted then there would need to be another flat plat e above the belt for the engine to bolt onto and unless the engine is running backwards the tension pulley is on the wrong belt run.
The PTO/Hydrostatic belt is mounted up top. In other words, the closest one to your behind, while sitting in the seat. In most cases, the deck belt must be removed to replace the hydro belt.
This video will help a bit. EverRide and Great Dane were under the Ariens/Gravely umbrella. The guy needs to blow off his mower.
This video will help a bit. EverRide and Great Dane were under the Ariens/Gravely umbrella. The guy needs to blow off his mower.
Last edited: