CAVIwiring
Forum Newbie
- Joined
- Mar 31, 2020
- Threads
- 1
- Messages
- 3
Me and my father replaced the drive belt on our Everride Warrior 60" yesterday, since the mower hadnt been runnin in 2 years. We had to take the pully, and the clutch off of the drive shaft to fix some wiring that got messed up when the belt ripped the wires apart. We rewired the clutch and started the mower with nothing on the drive shaft and the engine started and ran just fine. As soon as we put the V-belt pulley and the clutch back on the driveshaft, it wont start the engine now. The engine just ticks but doesnt spin or even try to start. When the pulley and clutch is on the driveshaft, we are unable to turn the engine as well (putting hands on top of engine and trying to turn it by the fan grill.
We have checked wiring, and everything but as soon as the clutch and v-belt pulley go on, the engine wont start. We tried to loosely tighten all bolts thinking it might be a tension issue, but still nothing. We also checked that the clutch and V-belt pulley arent touching anything that would be preventing the engine from turning.
(We did try starting the engine with and without the drive belt on to check if it was too much tension on the pulley, still nothing both ways)
Any help would be fantastic, please and thank you.
Tyler.
We have checked wiring, and everything but as soon as the clutch and v-belt pulley go on, the engine wont start. We tried to loosely tighten all bolts thinking it might be a tension issue, but still nothing. We also checked that the clutch and V-belt pulley arent touching anything that would be preventing the engine from turning.
(We did try starting the engine with and without the drive belt on to check if it was too much tension on the pulley, still nothing both ways)
Any help would be fantastic, please and thank you.
Tyler.