Do these work?

[PTmowerMech]

Saw this ad on facebook for a three jaw bearing puller. It looks like it might work pretty good.

Buys4life - 🔥Labor-saving 3-Jaw separation bearing device 💥LAST DAY SALE 50%OFF

- YouTube

Enjoy the videos and music you love, upload original content, and share it all with friends, family, and the world on YouTube.

youtube.com

 

[bertsmobile1]

Usually called a pilot bearing puller
A good one is around $ 100 Aus
Cheap ones the legs that grab the bearing are cast so break the first time you use it on a bearing that is anything tighter than a hand fit .

 

[Hammermechanicman]

Pro 16pc Blind Hole Pilot Bearing Puller Internal Extractor Remover Slide Hammer | eBay

1 x Counter stay puller. Split collet type Blind. Pro 10pc Bushing Bearing Race and Seal Installer Driver Set Auto Car Kit. Pro 9PC Hose Clamp Clip Plier Set Swivel Jaw Flat Angled Band Automotive Tools.

www.ebay.com

I have this set. Works good

 

[StarTech]

Pro 16pc Blind Hole Pilot Bearing Puller Internal Extractor Remover Slide Hammer | eBay

1 x Counter stay puller. Split collet type Blind. Pro 10pc Bushing Bearing Race and Seal Installer Driver Set Auto Car Kit. Pro 9PC Hose Clamp Clip Plier Set Swivel Jaw Flat Angled Band Automotive Tools.

www.ebay.com

I have this set. Works good

I looked into that set or similar set and I didn't like the reviews of the pullers breaking. Here I have been using the HF one with fairly good luck. Mostly pulling deck bearings.

https://www.harborfreight.com/slide-hammer-and-bearing-puller-set-5-piece-62601.html

 

[Scrubcadet10]

I looked into that set or similar set and I didn't like the reviews of the pullers breaking. Here I have been using the HF one with fairly good luck. Mostly pulling deck bearings.

https://www.harborfreight.com/slide-hammer-and-bearing-puller-set-5-piece-62601.html

i've had good luck with that one as well from Harbor freight,

 

[bertsmobile1]

I use grease to pop out blind bearings
For spindles I use the air hammer / chisel with a very long punch ( rivet setter )
They just fall out with 10,000 tiny taps a minute
Only down side is it took me 5 years to nut it out

 

[StarTech]

Just how are you just using grease to get the bushings and open needle bearings? Can see maybe the closed end ones.

 

[Hammermechanicman]

I looked into that set or similar set and I didn't like the reviews of the pullers breaking. Here I have been using the HF one with fairly good luck. Mostly pulling deck bearings.

https://www.harborfreight.com/slide-hammer-and-bearing-puller-set-5-piece-62601.html

Haven't broken one yet.

 

[Hammermechanicman]

I use grease to pop out blind bearings
For spindles I use the air hammer / chisel with a very long punch ( rivet setter )
They just fall out with 10,000 tiny taps a minute
Only down side is it took me 5 years to nut it out

Tried the grease and wet bread thing and then bought the tool. I'll go with the tool.

 

[bertsmobile1]

Just how are you just using grease to get the bushings and open needle bearings? Can see maybe the closed end ones.
View attachment 64638View attachment 64639

For the open needle roller I use a coach bolt with 2 flats ground on it and a slide hammer