Changed drive belt, now electric clutch doesnt engage.

splitty

Forum Newbie
Joined
Sep 25, 2016
Threads
1
Messages
1
  • / Changed drive belt, now electric clutch doesnt engage.
I have a 2007 lt 1045, It has been problem free. The original drive belt finally gave up the ghost. I pulled the clutch off hung it from the spring I took off the tensioner pully replaced the belt and put the clutch back on. Now when I pull the pto switch the clutch tries to engage but it wont spin. I can see the bottom plate move upwards but it wont spin. It doesn't bog the motor down either. Weird. Any advice would be greatly appreciated. I don't know anything about these clutches because I have never had an issue with one. I used an impact to tighten the clutch back up on the shaft, I'm guessing that's where I went wrong.
 
Top