christophert
Member
- Joined
- Aug 1, 2017
- Threads
- 15
- Messages
- 37
I need some help. I changed the bottom end gasket on a Briggs and Stratton 23HP Intek engine. I marked the governor shaft where it was set before I removed the sump. In my zeal to clean up the sump before I reinstalled it, I wiped off my reference mark. I have put the engine back on the mower and its over-revving. I readjusted the governor by holding the throttle wide open, turned the governor clockwise until it stops and tightened everything down. The engine idles fine at low RPM, but bump up the throttle slightly the RPM's go to high. Where should I go next? I appreciate any assistance!