I've got a 2017 Outlaw XP with a 54" deck. It's approaching 120 hours. I've already replaced one of the idler pulleys and the other 2 aren't far behind. My replacement was with a Capitol Stampings OEM style, but I'm starting to wonder about the quality of these. I noticed on Amazon that a company sells a replacement with replaceable bearings. It's called BigBearing Billet pulley. It sounds like a great idea, but I have little doubt that they come from China. Anyone have any experience with these.
- Joined
- Sep 7, 2024
- Threads
- 11
- Messages
- 907
Most manufactured parts come from sources all over the world. Primarily where labor is cheap and unions do not exist. Both good and bad parts are even manufactured right here in the United States.
- Joined
- Sep 24, 2017
- Threads
- 278
- Messages
- 6,761
They are part of the HD switch umbrella, Chinese, but alot of their stuff is good quality
I'll probably give a set of them a try. Even if the bearings don't last long, they are replaceable and I can use better bearings, such as Timkens.
- Joined
- Sep 7, 2024
- Threads
- 11
- Messages
- 907
Make sure you pack the bearings by hand to get plenty of grease into the inner race of the bearings. A majority of bearings fail due to minimal grease when they are assembled and greased at the factory. Minimal grease means a short lifespan.
I even remove the side seals on the "sealed bearings" to pack them and then put the seals back in place. It makes a huge difference in the life of the bearings.
I even remove the side seals on the "sealed bearings" to pack them and then put the seals back in place. It makes a huge difference in the life of the bearings.
Good suggestion! Thanks.