4x4 mower

Not that i'll ever get to start on it,but i've wanted to do a wild blown 4x4 mower.
I have went so far as to collect most of the needed parts though.
My plan is to use an old 4 wheel steer mower i've got.
They can be hard to find,but a buddy came across one for me about 5yrs ago.
Same buddy gave me the smog pump I intend to use for either a supercharger or to drive a small turbocharger i've got.

Anyway,4 wheel steer mower has a transaxle in rear that utilizes a cv joint type setup.
Pulley is on top.
I figure i'll use a combination of lower engine mounting along with a jackshaft to drive both the standard rear transaxle and the front mounted 4 wheel steer axle.
Gearing them could be done with using appropriate ratio pulleys.

The only actual building has been in my head,though I did mock one up at one time.
This was pre 4wheel steer transaxle,and I got as far as a 12" lift and didn't know about mowers or have a good welder so it was shelved and eventually mostly scrapped.

Post up if you build one,I would love to see it.
Look up the all terrain lawn mower association.
 
Back
Top