42E707 carb (19306) linkage diagram/help

C

curmudgeon555

Member
Replacing carb and now not sure how throttle linkages hook up. Throttle bracket (691366)does NOT have the nylon slider seen on other bracket videos. B&S engine is 42E707, type 2031-E1. Carb is 19306
Throttle cable is secured to clamp on intake manifold and the Z wire extends toward the carb.
Manual choke wire attaches directly to carb choke arm
Carb has plastic L shaped arm with holes on each leg, attached right next to the throttle plate lever. Perhaps throttle wire attaches to one of these holes and a small metal link attaches L lever to the throttle control lever??
That leaves one longer metal link to attach (I guess) to the governor control mechanism.....but where?
I have photos of things mentioned, but having problems attaching here. Email your address to [email protected]
Any help or directions would be appreciated
 
I will if I get the time this holiday weekend to pull the front of the old Lowes mower here and take some photos since one else can. Can't today as I am recharging the camera batteries.
 
Yes Gary that looks correct. I just through the turkey cooking so go pull the air cleaner on that Lowe's mower.
 
StarTech said:
Yes Gary that looks correct. I just through the turkey cooking so go pull the air cleaner on that Lowe's mower.
Click to expand...
Okay slight config problem. The linkages need reversing as the shorter goes to the throttle shaft on the carburetor and the longer one to the governor link.
1669317237590.png
Sorry for the slight mis-direct
 
This seems to be another one of those times it would have been smart to snap a few pictures before taking things apart so you could see how stuff gets put back together. I do this many times and has been worth the time.
 
You must log in or register to reply here.
Back
Top