25 horse kawasaki blowing out oil

E

eigerogre

Forum Newbie
My JD 757 zero mower blows oil out of the dipstick hole .Tried a new dipstick,its still coming out and getting blown by the fan on the hot muffler?????????
 
eigerogre said:
My JD 757 zero mower blows oil out of the dipstick hole .Tried a new dipstick,its still coming out and getting blown by the fan on the hot muffler?????????
Click to expand...

This happen straight up, like no prexisting symptoms/anomalies?
Try fixing the stick in anyway you can then post up how the engine performs.
Only a short run at load, like two minutes max.

KK
 
This mower is 15 yrs old,lots of hours on it.Oil started last year or so.It starts coming out after running 5 mins or so.Enough to make noticeable smoke from the hot muffler,and dripping on ground.Is it time for engine work?....Is there a blocked pcv valve somewhere?
 
eigerogre said:
This mower is 15 yrs old,lots of hours on it.Oil started last year or so.It starts coming out after running 5 mins or so.Enough to make noticeable smoke from the hot muffler,and dripping on ground.Is it time for engine work?....Is there a blocked pcv valve somewhere?
Click to expand...

...ummmm, mostly logic built from the info so I can only offer
"pcv valve" may have collapsed, you could get that lucky at those
amount of hours. However you are reporting a heavily pressurised
c'case which would have had a working valve choking the carby feed,
long before this. I'd bet on a broken ring, or two.
Good news is,,, at that age you likely have a reasonable case to rebuild
or simply hone and replace with OS rings.

KK
 
Run a compression check on both cylinders, sounds like it might have a lot of blow by on piston rings from age, if compression is low and it still runs ok you might wrap something around top of dipstick where it goes into tube to make a tighter fit. That might get you thru season then rebuild or replace this fall

Hopefully some more will add ideas.
 
eigerogre said:
No pcv shown in manual on this v-twin kawi 25
Click to expand...
Yeup...thought as much.
Your engine was built long before the current PC crap began. As others suggest, try and keep it going - drive it till it dies - a thicker (weight) dino oil may help with blowby.
Just do not let it run low as that may well and truly ruin your case.

Good Luck an' go well.

KK
 
You must log in or register to reply here.
Back
Top