kohler

have the following kohler courage 20hp engine sv600-0024 that has a crack in the upper crankcase due to bolts coming loose to top end of engine, looking for any suggestions to make repairs, mower belongs to 80 year old lady so she does not want to replace the crankcase due to cost and her age...

Got this out from winter storage in the shed. New battery today . Engine starts but is hammering loud and blowing lots of oil & smoke out the exhaust. Dies after about 10 seconds. I bought it new over 25 years ago. about 700 hours on it. Oil changes & filter every couple of years. My guess is...

Was replacing the water pump which is located behind the flywheel. While removing the transfer tube on the water pump going to casing on the motor the 90 degree fitting came out of the casing.It is not a threaded end and looks like it may have been pressed in.Has anyone had this happen to them...

Morning gents, I have a Toro Timecutter with a Kohler 7000 Series (34" Toro Timecutter 75734 - Kohler KT725-3097 to be exact). I already keep some belts, spark plugs, etc on hand in case I need them. Even if its just cheap Scamazon parts (just to keep things running in an emergency) what other...

My old Kubota with the 15 hp Kohler became almost impossible to start. For a year we struggled with getting it to fire strong enough to overcome the compression release. Once running it was powerful and ran normally. Then, getting it ready for this summer's mowing I could not get it to start...

So long story short I bought a 2003 Craftsman DGT6000 with a 27 HP Kohler Pro. Replaced both head gaskets and rebuilt the carb. Been In the shed for a week and today I went to blow the leaves into a pile and It didn't like it. It will run completely fine just driving around or even sitting still...

I currently have the displeasure of working on a Toro 522xi with a Kohler CH22 engine. While doing service on it I noticed it has a very small headgasket leak starting on the right side cylinder head. (The one with the oil fill port). It's a little hard to say but does this engine need to be...

I'm looking for a muffler for my ZTH6127 mower.

I have a Hustler 927806 with a Kohler CV740 engine. I bought this mower used and have been restoring it and now that I have it running, there is a problem with it running rough under load. It runs fine with full throttle and no load, but if I put some load on it such as blades engaged and going...

Hi, Does anyone know where to get the male mating connector to plug into the wire harness on a Kohler CV23 engine? Part numbers and manufacturer wouldn be greatly appreciated Thanks, Carey