Search results

I cleaned the tank and the carb. Before it would only run for a few seconds with fluid, I installed a new diaphragm and after turning the mixture screw (I guess my Pulsa-jet doesnt have a spring to seat the screw?) nearly all the way out, I was finally able to get it to start and run on gas...

Here are some photos. Not sure why you need them to "hop back on the wagon"? But here are most. Some show the place where the shaft broke, the intact key, interior of the engine, and...there are some others, but I cannot look at them until after I post, which right now, i am still typing the...

I am not sure what you mean, but I only have had this engine for a few months, and I did not break it with the drill. The extension did. King Kong? I am not sure what you mean by that but I wont take it offensively... As for photos, I will upload as many as you would like. I have some of the...

I was using the drill (15/16) to start my engine. However, once I got it started, the extension on the end of the socket spun out of orbit and broke the crankshaft just past the starter clutch. My issue before is that the pull start would and does not want to start the engine. The drill however...

Hello all. I am pretty familiar with engines, but this is my first tinker with a smaller engine. I have a Briggs and Stratton 5 HP. It is 130202, but uses the magneto and flywheel instead of points and condenser. I was trying to get this engine to run after buying a new fuel tank for it...