Search results

the 640020 is the correct carb for the tecumseh VLV mower. i did mount it on the engine, but just wanted to check if i did it correctly. sorry, you got upset.

its the metal piece that is shown in most ads for 640020 carb .

any idea how its attached?

i just ordered the above carb. it came with a metal shield? what is this for and how do you install it? thanks.

thanks for your response. can it be that the grease got hard, and so when tightened it stops them from turning?

hi all, i have a snapper awd sn625. i recently had occasion to remove the three pulleys. when i put them back in and tightened them to spec they would not turn. does this mean they are defective?

hi all, working on a troy built pressure washer. it uses an Annovi Reverbieri RMV2.2G24 water pump. it leaked out a lot of oil. I plan to replace the seals, but need to know the amout of oil to put in. I read somewhere that the amount was 2.2oz., is thar correct? it seems like such a small...

hi forum, o.k. here's my tale of woe. I have a eager 1 sears push mower. it has a Tecumseh 6.75 engine. I was mowing the lawn, and the lawn mower stopped. I tried to restart it. it did restart, but only ran a couple seconds. aha, I said the carb has a problem. so, I installed a new carb, new...

hi forum members, ordered new carb(640020). the new carb comes with a heat shield. two questions: how do you install it, what does it do? thank you.

I own an old craftsmen lawn mower that I'am trying to repair. it is a vector Tecumseh engine model 917.377591. I need to know the proper way the flywheel key is installed. the key number is 611154. did an extensive search on the net, with no result. any help would be appreciated. thanks.

echo model GT-220R. hard starting. fuel squirts out of muffler/spark arrester? all responses appreciated.

hi all, can someone tell me what the lo and hi rpm of most string trimmers? what rpm should they idle at? thanks.

hi all, just read an article about a small tach used to carbs. its called tiny tach and sells for around $50. it seems you tune the carb by using rpm. could someone explain how i could use this tach to tune 2 cycle walbro carbs?

this thread concerns a sears craftsman edger model 536-772100 engine #143-993502, carb #640156'the problem is the edger will run for 3-5 minutes then stop. i have done the following: cleaned carb, changed air filter, changed spark plug, cleaned gas tank, used fresh fuel. alas, all to no avail...