Search results

I can only get my Husqvarna 350 to start and run with the choke plate open ( choke button pressed in). It runs really hard and if it idles dies fast. If I pull the choke button out while it's running it dies. I've tried this with two carbs, the original which I cleaned, as well as a new carb...

Update: There is some growling coming out of the engine. If I crank it a ton with the choke pulled out, I can get an occasional growl to come out. When I press the choke in, I can get it to start after maybe 5 pulls, but then it runs crazy, super loud and fast (maybe super rich), sounds like...

The spark is good I've tested it. I will try setting a base tune on the carb, and fully removing the fuel line. What would you set it at to try starting?

I'm talking about the chainsaw. I have not done a compression test yet, but that is on my radar. I've tried to eyeball the cylinder, I don't see scoring but some light carbon buildup. I did not tune the new carb. Also to note is even with starting fluid I can't get one bark out of the engine...

I can try putting the old carburetor on but it wasn't working before. Really stumped with this one. The fuel line looked in decent condition.

I'm doing some troubleshooting on my Husqvarna 350. Trying to see if fuel is getting into the carburetor from the hose, where is the fuel valve or how can I test this? The spark is good and I put a new carburetor on, but the saw still won't run. It ran well last week for 30 minutes, but I tried...