Search results

Thanks, I was fooling around with it this morning and finally realized that, also after looking at the parts diagrams for the cylinder, which show the existence of the governor connected to that arm. I was able to adjust the arm's position on the pin and got the revs down quite a bit, possibly a...

Thanks. I had seen that parts breakdown, and unfortunately it does not show how spring 3 attaches from the bottom of the governor arm to the control assembly part 5. I have it in the upper of the 2 holes on the downward arm. Though the engine runs as below whether it is in one or the other hole...

OK, I give up. I removed and cleaned the carb, and after reinstalling it, the throttle plate does not rotate back to the idle position even when the throttle lever is at idle. It is basically at full throttle no matter what position the lever is in. I am almost certain it isn't the position of...

Thanks. That is a different spring or probably a different model of linkage.

Took the carb off my circa 1985 mower cleaned it and installed new carb bowl gasket. I am still having gas drip from it, but I'll remove it and recheck the seal. However, when I replaced the carb I noticed that the spring on the throttle linkage came loose and I had not noticed how it was...

HRA214 linkage