Search results

Thanks for the replies, I’ll be scraping it, save what I can for future rebulids. Geo ??

Hi All, this engine is on a pressure washer, originally ran out of oil, refilled with clean oil, ran fine for quite awhile until it stopped again, drained oil which was grey in color, when I tried to restart it just seemed to spin freely, I disassembled it, piston and rings seem fine at least...

Maybe not on vintage engines , this was built around 1954, yes I have looked on U tube, that was my first attempt. Thanks Geo??

Hi All, looking for a video for rebuilding a B&S carb, #99876, I believe that the venture in this carb is placed in the wrong position but I would like to confirm, is this tiny hole supposed to be clear? Can’t poke a paper clip through it. Thanks Geo??

Hi,probably because it’s an old model, I think I figured out . Thanks Geo ??

Sorry, here is the info. 6R6. S/N 371353. Type 105878.

Hi All, there are 2 wires on this magneto, 1 goes to ground terminated right on the mag mounting screw, where does the other wire connect? 1 obliviously there is the plug wire there also. Geo??

DELETE

Hi, what is the model number of the engine ? not the blower model .

The spring! I rechecked the governor shaft, linkage, spring, and it runs fine now , for an old mower.

IT FIXED! Who ever bet on the spring wins! Geo ??

Hi, I don’t do Utube, I was trying to upload a video but it won’t work.

That’s the one ordered and it’s to short , no real useful adjustment.

That’s the spring I have and it’s to short, didn’t see a video of this particular engine, the instructions that I used was to pull the governor rod in the direction that closed the throttle and watch the direction the governor shaft moves ,CCW, loosen clamp and turn shaft CCW and tighten clamp ...

Hi, from what I can tell it is the correct spring, it’s hard to find a part # but looking at different parts sites it’s the only number listed.

Hi, mower starts fine, can’t find a video on how to adjust the governor for this particular engine, so I did the following. 1. closed throttle and and watched the direction that the governor shaft turned, CCW . 2. loosened clamp screw and made sure governor shaft was all of the way CCW , which...

Hi, received the spring, adjusted the governor shaft per specs, with spring installed it starts but way over rev’s. any thoughts. Geo ??

Thanks, I will order one.

Hi All, I have a B&S 10T802 0547 B2 engine, on a push mower, it has no power, fresh gas, new plug, clean air filter, under deck clean, seems like the governor is not working correctly, it has been adjusted per specs , no springs involved just a straight rod from carb to governor shaft. almost...