Tiger Small Engine's latest activity

You are going from a Kohler K series engine (50 years old) to a Briggs twin engine. Wiring won’t be your only concern. This will require...

You’ll probably going to have to check under the unit, I’m thinking bad pulley on the drive tensioner arm. Post unit model and serial...

20W-50 synthetic for many hydraulic pumps, wheel motors, and transaxles. Yes

Good pre-mix oil such as Stihl synthetic (gray bottle) is more like $5 bucks per 2.5 gallon bottle, not $2 dollars. Ethanol is...

I couldn’t see it. Absolutely screaming. Don’t start it again.

Look like a Honda GCV160 engine with no push rods. I am sure this engine costs more to build, and therefore main reason it never caught...

That thing is screaming and don’t run it anymore like that or you will blow the connecting rod. How many RPMs is it running?

With a new aftermarket carburetor, and the engine is hunting and surging, it is running lean (not enough fuel). The air/fuel mixture...

It is a piece of junk, from the trimmer, to the trimmer head. If you have had enough, buy a better brand.

Keeping the angle consistent along the length of blade is one of the most important aspects of sharpening a mower blade correctly. I see...

You don’t put oil in spindles, you put grease.

Check your battery, charge it and have it load tested. It should be charging based on what you stated.

You need to be able to adjust the carburetor. If it will start and idle for about 10 seconds, it could be as simple as a carburetor...

TO ALL: Well... it turned out that it was one of the coils, the one to the inside facing the seat that was bad. Thanks to the youtube...

Compression is low for a 2-stroke if you are using a proper compression tester for small engines (Schraeder valve). You have spent a...