Rivets's latest activity

  • R
    I don’t know where to start, as the model numbers you posted don’t make a lot of sense. 1. The 990670 number comes back to a mower...
  • R
    That’s a new one on me, it’s just a pdf file. Everything I have is in that format. Try searching for “Briggs pulsa jet tank mounted...
  • R
    Have you taken any time to read the section on carbs in the manual I posted??? I’ll bet not. If you find a picture of the mounting...
  • R
    Another thing, when I get a 30 year old with this style carb/tank setup, I many times find the tank warpped. Tank most times is NLA so...
  • R
    I’m guessing it is time to replace the pump diaphragm. Also, I would replace the gasket between the carb and tank, making sure it is...
  • R
    Please provide us with the model and serial numbers from both the tractor and blower so we have a better idea of what you are dealing...
  • R
    Rivets replied to the thread Choke lever removal.
    Not everyone,. If you really knew what you’re doing you would know that the experienced techs on this forum need all engine numbers so...
  • R
    Depending on the engine model it not have one, but simply use a diode rectified system. Use this manual to identify which system you...
  • R
    Rivets replied to the thread Ignition switch.
    Post your units model and serial numbers. With them we can tell you which switch you need. Many switches look the same, but are very...
  • R
    Rivets replied to the thread 9P702-0149-F1.
    Check to see if it is Lazer etched into the side of the block.
  • R
    Rivets replied to the thread Missing Fuel Jet Spring?.
    Besides a plugged fixed jet, I’ve found that over time the float needle tip expands, resulting in a drop in fuel level in the float...
  • R
    Rivets replied to the thread blowing fuse.
    Here is the wiring diagram you will need...
  • R
    Rivets replied to the thread Name that mower game.
    Looks like a Simplicity tractor. Simplicity started building NFL and NCAA branded tractors about 1996. If I remember right, I think...
  • R
    Rivets replied to the thread blowing fuse.
    I wouldn’t go after the ignition switch before doing some electrical troubleshooting. Making any component assumptions could lead to...
  • R
    Rivets replied to the thread blowing fuse.
    A multimeter will be your best friend when troubleshooting this problem. If your daughter can get you the model number from under the...
Top