Rivets's latest activity

  • R
    Rivets replied to the thread New carburetor part # needed.
    Star, would you share where you found that part number? I looked for over 40 minutes and could not find the number for the older carb...
  • R
    Rivets replied to the thread drive pulley.
    We’ll probably never know!
  • R
    Rivets reacted to StarTech's post in the thread drive pulley with Like Like.
    If that is the case then the OP has a problem as I haven't seen a double stack pulley that is 1-1/8 ID. And I just had a problem with CC...
  • R
    Rivets replied to the thread drive pulley.
    Who are you thanking and what are you thanking us for?
  • R
    Rivets replied to the thread drive pulley.
    That’s not the full model number. I also see you’ve posted three threads about the same issue, that’s a NO NO. If your model number is...
  • R
    Rivets replied to the thread unusual pulley.
    I’m assuming you are referring to the drive pulley. We are going to need the model and serial numbers, normally located under the seat...
  • R
    Rivets replied to the thread Changed my mind.
    I’m not bad mouthing TORO, just the Super Recycler version.
  • R
    Rivets replied to the thread Starting Issue.
    Sounds like you have an intermittent short in a component or wiring harness. This is going to take some patient electrical...
  • R
    Rivets replied to the thread Z530M running issues.
    Stop everything. Do not try to fix even the most simplest thing. Voiding the warranty at this point could be the dumbest decision you...
  • R
    That number you posted is for Australia, might want to try the number for Wauwatosa
  • R
    Rivets replied to the thread Changed my mind.
    Guess you’ve never read my previous replies to what is the best push mower to purchase. I used to say that even the cost of the Toro...
  • R
    Rivets replied to the thread Changed my mind.
    While we were talking the one thing that really surprised me was when the owner said that Toro support was very poor on these mowers. I...
  • R
    Rivets posted the thread Changed my mind in Pro Talk.
    To all who have followed this forum for a long time, you will know that I have been a strong supporter of the Toro 21” Super Recycler...
  • R
    Try this site. https://www.briggsandstratton.com/au/en_au/support.html The date code should be listed in the same area as the model and...
  • R
    Rivets replied to the thread Husqvarna 128LD.
    What gave me the impression you thought it was a piece of junk??? 1. My cheap neighbor 2. Bought at a pawn shop for $20 3. Condition...
Top