Rivets's latest activity

Actually it is NOT. A fuel shutoff solenoid shuts off fuel flow into the carb. The afterfire solenoid doesn't effect fuel flow into...

The washer in your pictures is between the bearing hoc and drive gear, which is the part both I and IL say you need. You can question...

Toro part number is 110-7191, which is what you are looking for.

Just my opinion, but the deck in the picture shows a twisted deck.

As IL says double check your model number. 20055 is a cast deck, while your pictures show a steel deck.

Does this manual help you out? https://www.toro.com/getpub/22446

Not a separate part, will need to replace the carb, or find a used carb at a repair shop to scavenge the choke shaft.

This manual will tell you how to hook up, test, and adjust the governor...

First, check to see if you may have installed the coil upside down. Second, set the air gap at .010”. Check for spark with kill wire...

Look at page 34 of this service manual. https://resources.kohler.com/power/kohler/enginesUS/pdf/16_690_01_EN.pdf

Need to adjust the throttle control to fully open the throttle plate, where it attaches to the engine.

Need to adjust the throttle control to fully open the throttle plate, where it attaches to the engine.

You’ll probably going to have to check under the unit, I’m thinking bad pulley on the drive tensioner arm. Post unit model and serial...

Kohler part number for intake valve seal is 1403208S. Here is a parts diagram and service manual for your engine...

Boy, has this thread taken a left turn, OP said he got his answer in post #7. Don’t know how we got on charging or jump starting a unit.