MParr's latest activity

How can the valve be correct? It's obviously just a shut off valve. The valve should have a left, right, and off setting. This is your...

You would be surprised. There is no one deck setting to fit all. I have a Gravely Pro Turn 260. Gravely says to set the rear 1/4" to...

Use OEM blades or equivalent aftermarket blades. With that 72" deck, run it level all around. No forward pitch.

Ah now I see what you mean as if the pliers opening between the tips are enough they would work. It didn't even dawn on me but what does...

Here is the reassembly order I suggest you follow. 1. Admit that I’m smarter than those on this forum who have tried to help me. This...

Holy cow! I can't believe I just sat here and read through all 9 pages of this thread going back over a week! JimP2014, I do believe...

I've already suggested that he "call the man." Other than that, I'm done.

Not you for sure. I don’t know why I keep following this thread, but it has gotten so bad I have to warn others not to use anything you...

From service manual Yes either oil pressure has failed or the engine operating oil pressure has dropped below 14.2 psi. I have seen...

The only ways that pulley could be tilted is a bent bolt, wallowed out bolt mounting hole or bent mounting bracket. THE END!

I agree with Rivits's assumption. The black pulley looks tilted towards the fron of the deck. It also looks low to the spindle pulley...

Cool for the Snapper information. When I sharpened and balanced the Blade, it was severely out-of-balance. The blade material is super...

It could be a 214X1P