McTurff's latest activity

You take the wife's best big sharpest kitchen knife and place the sharp edge on which side of the gasket you like . Then you use the...

there should be a total of 7 bolts/studs holding the sump on. Check down those deep hole above and below the crankshaft. I think you...

Before doing anything more remove the key and bolt. Then take some medium/fine abrasive paper and polish the crankshaft until it is...

Take a heat gun and run it around the two halves of engine case where gasket is.

Thank you

Do you still have access to repair manuals for 40 through 42 series Thanks

Yup had the knife out I keep all knifes away from my wife! Thanks I'm taking a step back and can use some help! The reason I'm took...

I have to put a new sump gasket and governor in my 422707-121401 Briggs Engine is off machine and on bench 6 bolts removed from sump...

Do you by chance have repair manual for 422707-121401 Briggs??? Thanks

All tests have determined governor gear But have to replace crankcase seal anyway! Thanks Auto Doc If you have a repair manual I would...

Thanks I know how to set Governor I'm asking about replacing Governor Need to Crack open and install new one! Meaning new Governor Gear

I have to put a new Governor in my BRIGGS 422707-121401 opposed twin! Is the procedure the same as on a OHV Briggs??? Thanks Sorry...

I have to put a new Governor in my BRIGGS 422707-121401 opposed twin! Is the procedure the same as on a OHV Briggs??? Thanks

I have to put a new Governor in my BRIGGS 422707-121401 opposed twin! Is the procedure the same as on a OHV Briggs??? Thanks

Thank You