Recent content by mathissteve

Was running,mowing, a week later would not start. Cleaned,no issues found,blew out passages. Will start with gas or fluid, but as soon as start taking choke off,it stalls and won't start. Next day,same. If have both butterfly's open,can see gas in intake tube.

I guess I finally figured out why I had so much difficulty with this- somebody had this thing far enough apart, to install the idler bolt from the top down, there's no way to get it out,as the bolt cannot go up enough to remove,there's only about a half inch clearance on the top side. When I...

Finally got the belt on the 3pulleys on the left side of undercarriage, now, doesn't seem like quite enough slack to make it over the pulley on right. The tensioner is. At full slack. Cannot seem to get on any JD info pages for main drive belt diagram. I'm so over working on all my mowers...

I must have missed something, the pulley does not have enough clearance to the main drive pulley, can't take bolt out,no clearance for removal. There is a spacer under it to keep it at correct height. I will ck when I get back to shop,to verify pulley above is not repositionable to allow bolt...

I have a srx95, had a bad drive belt,,about impossible to get belt off of pulley above the axle housing,old belt had portion of vee missing,managed to get old one off, new belt ,can't seem to get belt over the tin shield that has 2 flaps to keep it from jumping. Loosened axle on left, but when...