Recent content by Jpow

  1. J

    Husqvarna YTH 22V42 cranks but wont start

    Was having the same challenge. Removed fuel solenoid, clipped plunger and reinstalled. Installed fuel shut off valve after carb and it starts every time and runs like a champ. All this after, replacing fuel, batter, fuel filter, spark plugs, fuel solenoid cleaning carb, etc....
  2. J

    Troubleshooting: engine won’t turn over, burning through solenoids?

    Was having the exact same challenges - the only way I could get it to start was with starter fluid. Changed, fuel, filter, plugs, cleaned carb and replaced solenoid to no avail. Finally, removed solenoid, clipped off plunger, installed fuel shut off valve after carb and presto! Starts and...
  3. J

    Husqvarna YTH 22V42 cranks but wont start

    Was having the same challenge. Removed fuel solenoid, clipped plunger and reinstalled. Installed fuel shut off valve after carb and it starts every time and runs like a champ. All this after, replacing fuel, batter, fuel filter, spark plugs, fuel solenoid cleaning carb, etc....
  4. J

    Husqvarna YTA18542 Will Crank But Not Start

    After trying everything, I simply removed solenoid, clipped the plunger off, added a fuel shut off valve and presto. Runs like a champ!
  5. J

    Mower runs fine for an hour then sputters and dies.

    Mine just would not start; it was firing but just would not turn over. Clipping the plunger worked like a champ
  6. J

    YTH WOULDN'T START UNLESS HIT WITH STARTER FLUID!!!

    I also inserted a check valve into the gas line which I open only during use and close when it is parked.
  7. J

    YTH WOULDN'T START UNLESS HIT WITH STARTER FLUID!!!

    "Mechanic" simply told me to change the battery - you are probably on to something here. But I think I'd rather deal with an occasional backfire then not being able to use it at all.
  8. J

    YTH WOULDN'T START UNLESS HIT WITH STARTER FLUID!!!

    Yes - even replaced the battery. Snipping the plunger seems to have solved the problem.
  9. J

    Mower runs fine for an hour then sputters and dies.

    Remove solenoid, clip plunger, install fuel shut off valve. That's the only way I could get mine to start and run and it has less than 100 hours on in
  10. J

    Understanding the solenoid on the carburetor bowl of some new Briggs Engines ?

    I had to cut the plunger within the solenoid off and install a fuel shut off valve to get mine to start and it has less than 100 hours. Tried doing all the logical stuff (plugs, filters, gas, carb) etc. It would only start when I hit it with starter fluid which I know is bad for the engine...
  11. J

    YTH WOULDN'T START UNLESS HIT WITH STARTER FLUID!!!

    Would not start in spite of having less than 100 hours. Ran like a top once I hit it with starter fluid which I know is horrible for the engine. So after changing plugs, cleaning carburetor, changing fuel filter, replacing gas - the problem persisted. Replaced the fuel solenoid and the...
  12. J

    B&S INTEK V-TWIN 22 HP COLD START ISSUES

    Will only spin at cold start but if you hit it with starting fluid will crank right up and run like a dream. Have replaced plugs, fuel filter and air filter to no avail. When warm/hot will start effortlessly. Any suggestions?
Top