ILENGINE's latest activity

If this is a single OHV briggs engine most likely either the valves are out of adjustment or the camshaft compression release is broken...

Looks like there is a 13565-7 and 13565-8 which is the 1987 or 1988 model year of the 40 inch deck. Also there is a 13607-7 which is a...

See if this applies. If not then we will need the actual model number starting with 13 to give better assistance

I have seen 2 with the Kohler crack and one that ventilated the rear block due to counterweight link failure. Also have a few in my...

I would try a new plug. Often times a plug will show fire in the open air but not work under cylinder compression pressure.

Hydrogear uses 20w50 from the factory, but also recommends using what ever the mower manufacturer recommends. I have seen mower...

The diagram also shows the one in the OP picture on another page of the IPL. I suspect that the carb has been replaced at one time...

Unfortunately those number are worthless for looking up part. Your first number is a casting number from the carb and is something is...

I have never seen a snow blower of any kind here. But looking over the IPL I see it has an idle speed adjustment since it would after a...

First thought was to see about a leakdown test, but then looked up the model number and found it is a 2 stroker. So I am thinking...

If it is leaking at the head, it is usually the valve cover gasket.

Most electric pto clutches has a brake that is supposed to stop the blades from turning after it is disengaged quickly instead of...

Have replaced the aluminum with steel a lot of times with no problems.

There is a number one and number two head. The number 1 is always the cylinder closest to the flywheel. Also If I remember correctly...

Winter