ILENGINE's latest activity

According to Toro the transmission used is a 104-1760 which translates to the hydrogear 310-0510 transaxle. Hydrogear list 79 oz of...

Engine brake only used on push mowers. And the reason for the hard pulling and the same reason for the long spindown is because vacuum...

Sorry ILENGINE,. My mistake. I was misinformed when I did a quick internet search this morning. Personally. I mistook the 7000 series...

Quality wide about the same, but the Briggs has some upgraded features that the other two don't I would choose either the Kaw or the...

The 7000 does not have hydraulic lifters. Still mechanical lifters since it is the newer version of the Courage twin. The only one...

One step below

I kinda leaning toward a downed push rod jamming the crank gear to cam gear and oil pump gear but is just a guess. A tear down is the...

No supercede, but also check your date code because the 590556 is used before 18070100 and the 84002104 used after 18063000, The...

The first and third pictures in your post are for the electric clutch version were you have the manual engagement.

Better than trying to remove Hondabond 4 that is grey at installation but will turn burnt black and crack and start leaking on the 7000...

If the air bleed passage is clogged it causes a rich run issue not lean. So from the prior OP post that is ran better with the air...

Hello R., Welcome to the forum. If I am not mistaken, this is a low output stator on a Briggs and Stratton that does not have a...

Connect red wire to battery positive.

The 3rd pulley from the left is find. It is supposed to be mounted on that angle to guide the belt coming off of the spindle pulley back...

Big difference between a GX and the GC/GCV listed in the OP. And as previously said could be a lean run issue that is causing the...