ILENGINE's latest activity

Don't confuse metric clearance with imperial clearance. He set the valves at .10 and .15mm which is roughly .004 to .005 inch.

May want to try a test light on that white wire to see if it will light a light. Just because a meter shows 12 volts doesn't mean it...

This maybe the closest you will find a diagram from MTD/SBD in some cases. But you can go find a similar Troybilt, Cub Cadet, Etc...

The Kawasaki part number for the complete carb is 15003-7037 JD price is pretty close to the Kawasaki list price.

Where are you getting these regulators from? Think I know where....... And having to move some pins around doesn't sound normal. Get a...

Snapper has been licensed by Briggs to DAYE. If I remember correctly production of the RER was ended a few years back.

Grasshopper 325 with the WG750 Kubota gas engine. Showing in the red when running, tried new temp sensor and that sensor reads higher...

I use the Kohler filter. 10 microns and extra capacity.

Rear side of the transmission toward the top center. Has a plug with 2 wires that is tucked up in the frame on the right side if facing...

It is the Tim Taylor effect. More power.

In some cases when 1 coil fails the other one is also going out, and in some cases with advance in part supercessions, a new coil can...

Spark with the kill wire disconnected proves the coil is fine, and it is not failing. So the issue is someplace between where it...

Pivot bar is the terminalogy that SBD uses for the front axle. Like Stihl uses rope rotor for the starter rope pulley

Don't focus so much on horsepower because unless you are mowing foot tall grass it will never be an issue. Rear engine riders have more...

With that wire disconnected you cannot shutoff the engine, without grounding that terminal or choking the engine. On some engines the...