Forest#2's latest activity

Thanks

I've found that a SERVICE manual for the RER's are very handy. Try flea bay with your model number and see if anything surfaces. I've...

Hello B, I have replaced quite a few main fuse holders for the problem you described. The next suspect is the ignition switch but be...

Briggs 254707 0124 01 code 92071730 Can anyone confirm crankshaft stub size on the 10hp engine as 1 inch dia x 3 inches long and...

When this cat decides to post valid equipment numbers then we know what he got for a mower. I manage to figure that he has a 44S877...

Chain link fence piping is usually thin wall construction and galvanized, any kind of welding will be a challenge.

I do check mine with a digital torque adapter. That how found out how lousy HFT torque wrenches were. One was nearly double the torque...

Lubing the bolt will cause u to overtorque them.

You are most likely SOL finding a 1 1/8 dia stack pulley. Most generally when someone needs such they have replaced a 1 inch shaft...

Pulley groove wear gauges

Something to add to the list like cub cadet troy bilt and husqvarna

Solenoid shift starter should keep the Bendix up; unless, the battery voltage is dropping below 9.5v. If the applied voltage is dropping...

If that is the case then the OP has a problem as I haven't seen a double stack pulley that is 1-1/8 ID. And I just had a problem with CC...

I don't recall B&S making an 11HP twin cylinder engine. I'm still wondering how a "16HP carburetor" was mounted to this. The original...

I suspect head gasket let go but ???????????? A engine model number, type and code would be helpful. (or even some pictures of the...